Tooling for EDM
397 risultati per 'Tooling for EDM'
Pneumatic chuck, MacroStd
3R-600.86-30
Pneumatic chuck for permanent mounting in the machine spindle. Note: When ordering state machine make and type. Note: X/Y/Z references of hardened and ground steel, larger Z-references.
Manual chuck, MacroHP
3R-600.20
For mounting on the machine spindle with 3R-A3620 or on a lathe taper with centring ring 3R-612.6.
Pneumatic chuck, MacroStd
3R-600.1-30
Pneumatic chuck for permanent mounting on the machine spindle or onto the machine table or as a lathe chuck.
Manual chuck, MacroStd
3R-610.21
Three ground faces for vertical or horizontal mounting on the machine table.
Manual chuck, MacroStd
3R-610.21-S
Two ground faces for vertical or horizontal mounting on the machine table.
Manual chuck, MacroStd
90842
Two ground faces for vertical or horizontal mounting on the machine table.
Pneumatic chuck (low profile), MacroStd
3R-602.81
Pneumatic chuck for permanent mounting on the machine table.
Collet chuck ER20, Matrix110
3R-699.20-110D
The pallet can be flipped over to gain access from rear side.
Manual chuck adapter, Matrix110-Ø20
3R-SP31380-RS
Intended to fit cut tools with Ø20 mm. Also adapted to fit System 3R Mini electrode holders with Ø20 mm.