144 results for "Tooling for wire EDM"

3R-228.1

Surface plate with reference stops, a mounting stone with bushings and holes for mounting a chuck/reference element and through holes for mounting on the surface plate, and a check stone. A dial indicator is required.

3R-228J

Stone with three ground faces, a reference element and a clearance stone. Together with a surface plate and a dial indicator, 3R-228J is an excellent presetting tool for a modest outlay.

3R-228U

Mounting stone with bushings and holes for mounting chuck/reference elements. Use together with existing measuring machine or surface plate and a dial indicator.

3R-200.1J-U

Universal 150 mm reference element, with oval holes, for all machines that have M8 holes in the machine table, 30 to 40 mm from the edge of the table.

3R-200.XJ-X

Reference elements for machines with zero-line table. The length (L), hole spacing (C) and hole edge spacing (B) of the hardened reference elements are matched to the machine in question. Note: When ordering, state machine mark and type.

3R-225.2

For positioning 3Ruler anywhere on the reference elements. The stops have adjusting screws for accurate alignment.

3R-225

Can be moved infinitely along the entire reference element.

D-30229-3

Rotation table with Matrix 185 interface. Note: The units are controlled by the machine. The mark and type of the machine must therefore be stated when ordering.

3R-209.1

Movable jaws of SuperVice design provide a wide clamping range for rectangular workpieces. Detachable Z-support tabs ensure simple setting-up.

3R-216.6

For setting angles on swivelling elements. Angles are set with gauge blocks.

3R-216

With magnetic attachments for setting angles on swivelling elements. Angles are set with gauge blocks.

3R-223

Used where vertical or horizontal displacement of workpiece or accessory is necessary.