Tooling for EDM
397 résultats pour 'Tooling for EDM'
Drawbar, Matrix185
3R-695.2-185
Note: In automation the gripper has to grip on the pallet and not on the drawbar.
Drawbar, Matrix220
3R-695.2-220
Note: In automation the gripper has to grip on the pallet and not on the drawbar.
Drawbar, Matrix260
3R-695.2-260
Note: In automation the gripper has to grip on the pallet and not on the drawbar.
Manual chuck, MacroCombi
3R-460.31-5
Chuck in HighPerformance version. Five ground surfaces for vertical or horizontal mounting on the machine table.
Plate 10 mm, MacroJunior
3R-SP19269
Used in combination with 3R-491E when soldering round (<50 mm) or square (<40 mm) copper blanks. Permits mounting in MacroCombi chucks.
Holder 25 mm, MacroJunior
3R-461-8.8-HP
Upper and lower faces ground parallel within 0.002 mm. Locating pin Ø8.8 mm (0/0.05 mm).
Holder with taper, MacroJunior
3R-465.1E-A
The taper is machined suitably for attaching very small electrodes. To be mounted on 3R-491E with three screws MFT4x12.