Tooling for wire EDM

3R-239.3

For clamping round workpieces. To be mounted on 3Ruler or holder 3R-237.2, 3R-292.66HP or 3R-239-XXX.

3R-239.2

For clamping thin workpieces.

3R-225.2

For positioning 3Ruler anywhere on the reference elements. The stops have adjusting screws for accurate alignment.

3R-239.11

Movable jaws for mounting two rectangular workpieces at the same time. Detachable Z-support tabs ensure simple setting-up.

3R-239.20

Kit for clamping rectangular, round or thin workpieces.

3R-294.2

For clamping workpieces up to 50 mm. Mounts on 3R-237.2, 3R-294, 3R-292.66HP or a ruler in the 3Ruler system or Macropallet 54x54 mm.

3R-294.1

For clamping workpieces up to 17 mm. Mounts on 3R-237.2, 3R-294, 3R-292.66HP or rulers in the 3Ruler system.

3R-294.6

For mounting four workpieces Ø5-13 mm at the same time. Mounts on 3R-237.2, 3R-294, 3R-292.66HP or a ruler in the 3Ruler system.

3R-261.1_

For mounting directly on the machine table.

3R-239.25

Support bracket. For 3Ruler.

3R-A239.1

Clamps for clamping rulers on reference elements.

3R-239.22

Support tab adjusted by -5 mm. For 3Ruler.