Tooling for wire EDM
144 résultats pour 'Tooling for wire EDM'
Grip, Wire EDM
3R-WP1
Enables automatic changing of 3R-206.10, 3R-208.6, 3R-266.5, 3R-622.6 or customer-made fixtures.
Manual chuck adapter, Mini
3R-252.1
Chuck adapter with dual hydraulic chambers for Mini holders in the WEDM-system.
Presetting kit, Econo, Wire EDM
3R-228EI
Mounting stone with bushings and holes for mounting chuck/reference elements. Use together with existing measuring machine or surface plate. Note: 3R-228EI delivers with dial indiactor measuring inch.
Sine ruler, Wire EDM
3R-216
With magnetic attachments for setting angles on swivelling elements. Angles are set with gauge blocks.
Sine ruler, Macro, Wire EDM
3R-216.6
For setting angles on swivelling elements. Angles are set with gauge blocks.
Control rod, Wire EDM
3R-606.2
Master for determining the position of vertical Macro chucks. Cylinder ground to the Macro references. Supplied with engraved dimensions in the X-, Y- and Z-directions.
Wire alignment unit, Wire EDM
3R-220.3
Unit with double-insulated reference contacts for wire alignment.
Pneumatic chuck (low profile), Macro, Wire EDM
90945.01
Pneumatic chuck for permanent mounting on the machine table.
Angle Tool, Macro, Wire EDM
D-30215
Angle tool, Macro with vernier scale -90º to 0 to +90º. Note: Macro chuck is required on the machine table for clamping.
3R-block, Macro, Wire EDM
3R-217-1
Manual Macro chuck. For vertical or horizontal mounting on the machine table, or alternatively the WEDM system with the aid of 3R-SP6435.