Tooling for wire EDM
144 résultats pour 'Tooling for wire EDM'
Presetting kit, Econo, Wire EDM
3R-228EI
Mounting stone with bushings and holes for mounting chuck/reference elements. Use together with existing measuring machine or surface plate. Note: 3R-228EI delivers with dial indiactor measuring inch.
Sine ruler, Wire EDM
3R-216
With magnetic attachments for setting angles on swivelling elements. Angles are set with gauge blocks.
Sine ruler, Macro, Wire EDM
3R-216.6
For setting angles on swivelling elements. Angles are set with gauge blocks.
Control rod, Wire EDM
3R-606.2
Master for determining the position of vertical Macro chucks. Cylinder ground to the Macro references. Supplied with engraved dimensions in the X-, Y- and Z-directions.
Control ruler, Wire EDM
3R-206.10
Control ruler for horizontal Macro chucks. One long side ground to the Macro references. Supplied with engraved dimensions in the X-, Y- and Z-directions.
Wire alignment unit, Wire EDM
3R-220.3
Unit with double-insulated reference contacts for wire alignment.
Universal holder, Wire EDM
3R-293.33
Holder for round workpieces Ø8-100 mm, or rectangular workpieces up to 100 mm.
Universal holder, Magnum, Wire EDM
3R-293.66HP
For round workpieces Ø15-150 mm diameter, or rectangular workpieces up to 150 mm. Note: Mounts on HP, Magnum or MacroTwin mounting head.
Universal holder, Wire EDM
3R-292.3S
Holder for round workpieces up to 90 mm, or rectangular workpieces 100x90 mm.
Holder, Wire EDM
3R-237.1
Stainless steel hardened “do-it-yourself” holder. With start hole for wire EDM of the required shape for clamping one or more workpieces.