Tooling for EDM
397 résultats pour 'Tooling for EDM'
Manual chuck, MacroHP
3R-600.24-4RS
Rust resistant chuck for Macro holder. Mounts on a suitable fixture.
Rotating spindle, Macro
3R-6.600-VHS
For clamping in a horizontal or vertical Macro chuck. Flushing via the spindle or an external flushing connection.
Manual chuck adapter 90°, Macro-Macro
3R-652.9
For horizontal mounting of Macro holders. Supplied with drawbar for screw locking.
Manual chuck adapter 90°, Macro-MacroJunior
3R-406.9
For horizontal mounting of MacroJunior holders in the Macro system. Screw locking.
Pneumatic built-in chuck, Matrix110
3R-SP28395
Chuck for permanent mounting in the machine table or into a PM press.
Pneumatic built-in chuck, Matrix185
3R-SP28268
Chuck for permanent mounting in the machine table or into a PM press.
Reference tables, 3Refix
3R-936-60.38
Reference tables of structurally-stable toughened steel (270-320 HB). Hardened bushes in dead-end holes for 3Refix mandrels Ø20 mm at 100x100 mm modular spacing, as well as M12 tapped mounting holes with 50x50 mm modular spacing. Note: Customised reference tables can be made to order. Note: Hardened reference tables (650-700 HB) can be made to order.
3Refix mandrel, 3Refix
3R-901-10RS
Note: When positioning with 3Refix mandrels –always tighten the expanding mandrel in the R0 hole first.
3Refix mandrel, 3Refix
3R-901-20E
Note: When positioning with 3Refix mandrels –always tighten the expanding mandrel in the R0 hole first.
Slotted bushes, 3Refix
3R-903-20.235
Bushes of hardened spring steel 54 HRC. Outside diameter 23.5mm