Tooling for EDM

3R-460.83-2

Pneumatic chuck for mounting directly on the machine spindle. All XYZ-references in hardened and ground steel. Note: When ordering state machine make and type.;

3R-410.31-5

Chuck in High Performance version. Five ground surfaces for vertical or horizontal mounting on the machine table.

3R-SP19143

Stainless steel chuck with ground flange Ø22x6 mm for mounting in a fixture or the WEDM system. Axial locking screw with channel for flushing through the electrode.

3R-460.86-2

Pneumatic chuck for mounting directly on the machine spindle. All X/Y/Z references in hardened and ground steel. Note: When ordering state machine make and type.

3R-410.1-M

For mounting on the machine spindle or in a fixture on the machine table.

3R-400.34

For mounting in the machine spindle by means of 3R-A11489, or on the machine table by means of 3R-A19724 or alternatively 3R-A21944, or in a fixture.

3R-659.16-P

Chuck for collets ER16.

3R-659.32-P

Chuck for collets ER32.

3R-659.20-P

Chuck for collets ER20.

3R-494-D32x50

Blanks mounted on MacroJunior holders for the manufacture of electrodes. The stock range is matched to local preferences and ways of working. This applies to electrode materials, different grades of graphite and copper, and to dimensions. Contact your local 3R representative for further information. The System 3R factory can supply holders with factory-mounted copper blanks in sets of ten.

3R-494-S40x50

Blanks mounted on MacroJunior holders for the manufacture of electrodes. The stock range is matched to local preferences and ways of working. This applies to electrode materials, different grades of graphite and copper, and to dimensions. Contact your local 3R representative for further information. The System 3R factory can supply holders with factory-mounted copper blanks in sets of ten.

3R-322-50E

Holder with hardened reference part and unhardened electrode mounting part.