Tooling for wire EDM
144 résultats pour 'Tooling for wire EDM'
Unimatic Adapter SuperVice/Macro WEDM, Wire EDM
C950480
Adapter for System 3R clamping elements with adaptation height 15 / 25 mm: with Unimatic dovetail slide.
Pneumatic chuck (low profile), Macro, Wire EDM
90945.01
Pneumatic chuck for permanent mounting on the machine table.
Angle Tool, Macro, Wire EDM
D-30215
Angle tool, Macro with vernier scale -90º to 0 to +90º. Note: Macro chuck is required on the machine table for clamping.
3R-block, Macro, Wire EDM
3R-217-1
Manual Macro chuck. For vertical or horizontal mounting on the machine table, or alternatively the WEDM system with the aid of 3R-SP6435.
Automatic indexing chuck, Wire EDM
D-30206
Pneumatic built-in chucks for Macro holders. Can also be used in milling and grinding operations without high cutting forces.
Rotation table with Matrix 185 interface, Wire EDM
D-30229-3
Rotation table with Matrix 185 interface. Note: The units are controlled by the machine. The mark and type of the machine must therefore be stated when ordering.
Air unit, Wire EDM
3R-611.60
Unit for operating pneumatic chucks in B-axes. Two functions – open/closed with four seconds delay for air-blast cleaning.
Reference element WEDM, Wire EDM
3R-200.XJ-X
Reference elements for machines with zero-line table. The length (L), hole spacing (C) and hole edge spacing (B) of the hardened reference elements are matched to the machine in question. Note: When ordering, state machine mark and type.
Manual chuck, Macro
3R-602.27-1
Chuck adapter with lever for Macro holder in the WEDM system. Note: When mounted on the reference element, the two clamping jaws must be tightened with the same torque, 4 Nm.