Tooling for wire EDM
144 résultats pour 'Tooling for wire EDM'
Vice, Macro, Wire EDM
3R-613.6
Vice for mounting rectangular workpieces 0-80 mm in the Macro system. Movable jaws for centred mounting. Can be supplemented with insert 16115-00 for mounting round workpieces 15-55 mm.
V-holder, Macro, Wire EDM
3R-207.6
For clamping round workpieces 8-70 mm, or rectangular workpieces 10-52 mm in the Macro system.
SuperVice, Mini, Wire EDM
3R-213.4
Vice for mounting rectangular workpieces up to 25 mm in the Mini system.
Levelling adapter, Wire EDM
3R-272HP
For manual mounting of SuperVice, a holder or a fixture in the WEDM system. Note: All holders including HP can be mounted. Also fits the ICS system if the clamping jaw (17850-00) is changed.
Levelling adapter, Macro
3R-262HP
For mounting SuperVice, a holder or a fixture in the Macro system. Note: All holders including HP can be mounted.
Swivelling element 360° with encoder, Macro
D-30232
Swivelling element with manual Macro chuck. Display included.
Vertical fixed adapter, Macro
3R-226.6
For horizontal clamping SuperVice and holders in vertical Macro chucks.
Vertical levelling adapter, Macro
3R-262.6
For horizontal mounting of SuperVice and holders in vertical Macro chucks.
Levelling adapter, Wire EDM
3R-232S
For mounting SuperVice, a holder or a fixture directly on the machine table. Note: All holders including HP can be mounted.
Rotation table with Matrix 185 interface, Wire EDM
D-30229-3
Rotation table with Matrix 185 interface. Note: The units are controlled by the machine. The mark and type of the machine must therefore be stated when ordering.
Air unit, Wire EDM
3R-611.60
Unit for operating pneumatic chucks in B-axes. Two functions – open/closed with four seconds delay for air-blast cleaning.