Tooling for wire EDM
144 résultats pour 'Tooling for wire EDM'
Reference element WEDM, Wire EDM
3R-200.1J-U
Universal 150 mm reference element, with oval holes, for all machines that have M8 holes in the machine table, 30 to 40 mm from the edge of the table.
Reference element WEDM, Wire EDM
3R-200.XJ-X
Reference elements for machines with zero-line table. The length (L), hole spacing (C) and hole edge spacing (B) of the hardened reference elements are matched to the machine in question. Note: When ordering, state machine mark and type.
Control rod, Wire EDM
3R-606.2
Master for determining the position of vertical Macro chucks. Cylinder ground to the Macro references. Supplied with engraved dimensions in the X-, Y- and Z-directions.
Control ruler, Wire EDM
3R-206.10
Control ruler for horizontal Macro chucks. One long side ground to the Macro references. Supplied with engraved dimensions in the X-, Y- and Z-directions.
Wire alignment unit, Wire EDM
3R-220.3
Unit with double-insulated reference contacts for wire alignment.
Manual chuck adapter, MacroJunior
3R-466.40RS
Chuck adapter, stainless steel, for MacroJunior holders in the Macro system. Axial locking screw.