Tooling for EDM
397 résultats pour 'Tooling for EDM'
Manual chuck, MacroCombi
3R-460.34
For mounting in the machine spindle by means of 3R-A11489, or on the machine table by means of 3R-A19724 or alternatively 3R-A21944, or in a fixture.
Pneumatic chuck, MacroCombi
3R-SP18286
Pneumatic chuck for building-in, for example in a fixture, dividing head or B-axis.
Pneumatic chuck, MacroCombi
3R-SP19047
Pneumatic chuck for building-in, for example in a fixture, dividing head or B-axis.
Manual chuck adapter 90°, MacroJunior
3R-467.9-1
For horizontal mounting of MacroJunior holders. Screw locking. Note: For EDM machining only..
Pallet 25 mm, MacroJunior
3R-491E
For copper or graphite electrodes. NOTE: The electrode is installed with screw and adhesive assembly, or alternatively brazing.
Pallet 25 mm, ground, MacroJunior
3R-491E-HP
Top and bottom faces parallel-ground to within 0.002 mm. NOTE: The electrode is installed with screw and adhesive assembly, or alternatively brazing.
Plate 10 mm, MacroJunior
3R-SP19269
Used in combination with 3R-491E when soldering round (<50 mm) or square (<40 mm) copper blanks. Permits mounting in MacroCombi chucks.
Holder 25 mm, MacroJunior
3R-461-8.8-HP
Upper and lower faces ground parallel within 0.002 mm. Locating pin Ø8.8 mm (0/0.05 mm).
Holder with taper, MacroJunior
3R-465.1E-A
The taper is machined suitably for attaching very small electrodes. To be mounted on 3R-491E with three screws MFT4x12.
Electrode holder Ø20 mm, Mini
3R-322-50E
Holder with hardened reference part and unhardened electrode mounting part.
Pneumatic chuck, Matrix185
3R-690.1-185
Chuck for permanent mounting on the machine table or into a PM press.