Tooling for EDM
397 results for 'Tooling for EDM'
Pneumatic chuck adapter, Dynafix
3R-772-600A
Chuck adapter with built-in pneumatic Macro chuck for mounting in 3R-770-1A or 3R-770-5A.
Pneumatic chuck adapter, Dynafix
90356.21
Chuck adapter with built-in pneumatic MacroCombi chuck for mounting in 3R-770-1A or 3R-770-5A.
Reference tables, 3Refix
3R-936-60.38
Reference tables of structurally-stable toughened steel (270-320 HB). Hardened bushes in dead-end holes for 3Refix mandrels Ø20 mm at 100x100 mm modular spacing, as well as M12 tapped mounting holes with 50x50 mm modular spacing. Note: Customised reference tables can be made to order. Note: Hardened reference tables (650-700 HB) can be made to order.
3Refix mandrel, 3Refix
3R-901-10RS
Note: When positioning with 3Refix mandrels –always tighten the expanding mandrel in the R0 hole first.
Master pallet, Dynafix
3R-776.1-2
For alignment of the Dynafix references. With ground reference rulers, hole and surface.
Slotted bushes, 3Refix
3R-903-20.235
Bushes of hardened spring steel 54 HRC. Outside diameter 23.5mm
Pneumatic chuck, GPS240
C219110
Pneumatic table chuck, mainly intended for applications in die-sinking EDM machines.
Dummy chuck, GPS240
C210060
Dummy chuck for clamping a GPS240 pallet on a exchange or draining station.
Pneumatic chuck with built-in Macro chuc, GPS240
C219650
Pneumatic chuck with built-in Macro chuck. Intended mainly for measuring machines. The following pallets can be mounted in GPS240 by means of C 219 650: Macro 54x54 mm and Macro 70x70 mm