Tooling for powder compacting

45 results for 'Tooling for powder compacting'

« 2 3 4 »

To disable indexing feature on Matrix220 and Matrix260 chucks.

Index blocker-pin, Matrix220 and Matrix260

3R-SP29559E

To disable indexing feature on Matrix220 and Matrix260 chucks.

Handle to circumvent pallet for easier lift off chuck.

Handle, Matrix142

3R-692.7-142

Handle to circumvent pallet for easier lift off chuck.

Handle, Matrix185

3R-692.7-185

Handle to circumvent pallet for easier lift off chuck.

In combination with 3R-692.7-110 and 3R-692.7-142 to enable lift by crane.

Lifting device, Matrix110 and Matrix142

3R-692.8-142

In combination with 3R-692.7-110 and 3R-692.7-142 to enable lift by crane.

In combination with 3R-692.7-185 and 3R-692.7-220 to enable lift by crane.

Lifting device, Matrix185 and Matrix220

3R-692.8-220

In combination with 3R-692.7-185 and 3R-692.7-220 to enable lift by crane.

This fixture enables adjustment of punches within metal powder compacting by Macro system. The fixture is a stand-alone unit. It is possible to replace the indicators with electrical sensors. Free access from underneath, to access fixation-screws for the pallets.

Alignment and control tool for the Macro + 3Refix system in PM. Alignment is rough but helps reduce assembly time before final verification and alignment with verification tools. Also to be used to check parallelism between punch levels versus die-plate-level.

Alignment tool & control Z-distance, Macro PM

90909

Alignment and control tool for the Macro + 3Refix system in PM. Alignment is rough but helps reduce assembly time before final verification and alignment with verification tools. Also to be used to check parallelism between punch levels versus die-plate-level.

Requires computer etc by D-20189-BASE.
To be used in combination with punch unit D-20198-Zxx.

Die unit for Z-distance

D-20198-DZxx

Requires computer etc by D-20189-BASE. To be used in combination with punch unit D-20198-Zxx.

Tool to establish Z-distance in combination with either 3Refix or Matrix 142 pallet. This unit requires additional tool.
It is possible to apply electrical or mechanical indicators while measuring top surface.
Note: Linear probe is not included.

Punch unit for Z-distance, Macro

D-20198-Zxx

Tool to establish Z-distance in combination with either 3Refix or Matrix 142 pallet. This unit requires additional tool. It is possible to apply electrical or mechanical indicators while measuring top surface. Note: Linear probe is not included.