Tooling for parts production
416 results for 'Tooling for parts production'
Pneumatic built-in chuck, Matrix260
3R-SP28345
Chuck for permanent mounting in the machine table or into a PM press.
Control ruler, Matrix260
3R-696.1-260
For setting flatness and angular positions. Ground hole for centering.
Manual chuck (low profile), MacroStd
3R-600.28-S
Cast chuck with ground back face for mounting on the machine spindle. Also suitable in a fixture on the machine table or with adapterplate 3R-A26488.
Pneumatic chuck, MacroHP
3R-600.15-3
Rust resistant pneumatic chuck for permanent mounting on the machine table.
Pneumatic chuck, MacroStd
3R-600.84-30
Pneumatic chuck for permanent mounting in the machine spindle. Note: XYZ-references of hardened and ground steel, larger Z-references. Note: When ordering state machine make and type.;
Pneumatic chuck, MacroStd
3R-600.86-30
Pneumatic chuck for permanent mounting in the machine spindle. Note: When ordering state machine make and type. Note: X/Y/Z references of hardened and ground steel, larger Z-references.
Manual chuck, MacroHP
3R-600.20
For mounting on the machine spindle with 3R-A3620 or on a lathe taper with centring ring 3R-612.6.