Tooling for EDM
397 results for 'Tooling for EDM'
Drawbar, Matrix220
3R-695.2-220RS
Note: In automation the gripper has to grip on the pallet and not on the drawbar.
Control ruler, Matrix220
3R-696.1-220
For setting flatness and angular positions. Ground hole for centering.
Pneumatic chuck, Matrix260
3R-690.1-260
Chuck for permanent mounting on the machine table or into a PM press.
Pneumatic built-in chuck, Matrix260
3R-SP28345
Chuck for permanent mounting in the machine table or into a PM press.
Control ruler, Matrix260
3R-696.1-260
For setting flatness and angular positions. Ground hole for centering.
Pallet, Maxi
3R-29.2
Pallet with 16 clearance holes for M6 screws and eight M6 threads. Also works as a control ruler to set location of center.
Reference element 54x54 mm, MacroHP
3R-651.7E-P
Hardened and precision-cast, with clearance holes for four fixing screws. Note: Must be mounted on the workpiece/fixture before it is locked in a chuck.
Reference element 54x54 mm, MacroStd
3R-651.7E-S
Hardened reference element for copper electrodes and workpieces. Note: Must be mounted on the copper blank/workpiece before it is locked in a chuck. Note: For graphite electrodes, spacer plate 3R-658.1E-S is required.
Holder, MacroJunior
3R-465-LE
For round electrodes Ø4-8 mm or square < 8x18 mm, and with maximum height 30 mm.
Blanks, MacroJunior
3R-494-D10x50
Blanks mounted on MacroJunior holders for the manufacture of electrodes. The stock range is matched to local preferences and ways of working. This applies to electrode materials, different grades of graphite and copper, and to dimensions. Contact your local 3R representative for further information. The System 3R factory can supply holders with factory-mounted copper blanks in sets of ten.