Tooling for wire EDM
144 results for 'Tooling for wire EDM'
Presetting kit, Econo, Wire EDM
3R-228EI
Mounting stone with bushings and holes for mounting chuck/reference elements. Use together with existing measuring machine or surface plate. Note: 3R-228EI delivers with dial indiactor measuring inch.
Sine ruler, Wire EDM
3R-216
With magnetic attachments for setting angles on swivelling elements. Angles are set with gauge blocks.
Sine ruler, Macro, Wire EDM
3R-216.6
For setting angles on swivelling elements. Angles are set with gauge blocks.
Control rod, Wire EDM
3R-606.2
Master for determining the position of vertical Macro chucks. Cylinder ground to the Macro references. Supplied with engraved dimensions in the X-, Y- and Z-directions.
Control ruler, Wire EDM
3R-206.10
Control ruler for horizontal Macro chucks. One long side ground to the Macro references. Supplied with engraved dimensions in the X-, Y- and Z-directions.
Wire alignment unit, Wire EDM
3R-220.3
Unit with double-insulated reference contacts for wire alignment.
Reference element WEDM, Wire EDM
3R-200.XJ-X
Reference elements for machines with zero-line table. The length (L), hole spacing (C) and hole edge spacing (B) of the hardened reference elements are matched to the machine in question. Note: When ordering, state machine mark and type.