Tooling for EDM
397 results for 'Tooling for EDM'
Reference element Ø75 mm, MacroNano
3R-651.75E-N
Hardened and precision-cast with clearance holes for eight fixing screws. Note: Must be mounted on the workpiece/fixture before it is locked in a chuck.
Manual chuck, MacroStd
3R-600.23-S
Cast chuck with mounting flange for mounting on the machine spindle or in a fixture.
Manual chuck (low profile), MacroStd
3R-600.28-S
Cast chuck with ground back face for mounting on the machine spindle. Also suitable in a fixture on the machine table or with adapterplate 3R-A26488.
Pneumatic chuck, MacroHP
3R-600.15-3
Rust resistant pneumatic chuck for permanent mounting on the machine table.
Pneumatic chuck, MacroStd
3R-600.84-30
Pneumatic chuck for permanent mounting in the machine spindle. Note: XYZ-references of hardened and ground steel, larger Z-references. Note: When ordering state machine make and type.;
Manual chuck, MacroHP
3R-600.20
For mounting on the machine spindle with 3R-A3620 or on a lathe taper with centring ring 3R-612.6.
Pneumatic chuck, MacroStd
3R-600.1-30
Pneumatic chuck for permanent mounting on the machine spindle or onto the machine table or as a lathe chuck.