Tooling for wire EDM
144 results for 'Tooling for wire EDM'
Presetting kit, Econo, Wire EDM
3R-228EI
Mounting stone with bushings and holes for mounting chuck/reference elements. Use together with existing measuring machine or surface plate. Note: 3R-228EI delivers with dial indiactor measuring inch.
Pneumatic chuck, MacroTwin, Wire EDM
3R-602.12-1
Pneumatic chuck for Macro or MacroTwin. Horizontal mounting on the machine table. Note: On automatic changing with WorkPal - MacroTwin holders only.
Manual chuck, Macro, Wire EDM
3R-600.23RS
Manual chuck with mounting flange for Macro holder. Designed for permanent mounting.
Control ruler, Wire EDM
3R-206.10
Control ruler for horizontal Macro chucks. One long side ground to the Macro references. Supplied with engraved dimensions in the X-, Y- and Z-directions.
Wire alignment unit, Wire EDM
3R-220.3
Unit with double-insulated reference contacts for wire alignment.
Angle Tool, Macro, Wire EDM
D-30215
Angle tool, Macro with vernier scale -90º to 0 to +90º. Note: Macro chuck is required on the machine table for clamping.
3R-block, Macro, Wire EDM
3R-217-1
Manual Macro chuck. For vertical or horizontal mounting on the machine table, or alternatively the WEDM system with the aid of 3R-SP6435.