Tooling for EDM
397 results for 'Tooling for EDM'
Reference element Ø75 mm, MacroNano
3R-651.75E-N
Hardened and precision-cast with clearance holes for eight fixing screws. Note: Must be mounted on the workpiece/fixture before it is locked in a chuck.
Reference element 70x70 mm, MacroNano
3R-601.7-N
Hardened and precision-cast, with clearance holes for four fixing screws. Note: Must be mounted on the workpiece/fixture before it is locked in a chuck.
Control ruler, MacroNano
3R-606-N
Control ruler with ground C-reference for setting MacroNano chucks.
Manual chuck (low profile), MacroStd
3R-600.28-S
Cast chuck with ground back face for mounting on the machine spindle. Also suitable in a fixture on the machine table or with adapterplate 3R-A26488.
Pneumatic chuck, MacroHP
3R-600.15-3
Rust resistant pneumatic chuck for permanent mounting on the machine table.
Pneumatic chuck, MacroStd
3R-SP24460
Pneumatic chuck for building-in, for example in a fixture, dividing head or B-axis.
Pnematic chuck, MacroHP
3R-SP26771
Pneumatic chuck for building-in, for example on machine spindle or fixture.
Pneumatic chuck, MacroHP
3R-SP26771-RS
Rust resistant pneumatic chuck for building-in, for example in a fixture, dividing head or B-axis.
Pneumatic chuck, MacroStd
3R-600.84-30
Pneumatic chuck for permanent mounting in the machine spindle. Note: XYZ-references of hardened and ground steel, larger Z-references. Note: When ordering state machine make and type.;