Tooling for wire EDM
144 results for 'Tooling for wire EDM'
Presetting kit, Econo, Wire EDM
3R-228EI
Mounting stone with bushings and holes for mounting chuck/reference elements. Use together with existing measuring machine or surface plate. Note: 3R-228EI delivers with dial indiactor measuring inch.
3R-block, Macro, Wire EDM
3R-217-1
Manual Macro chuck. For vertical or horizontal mounting on the machine table, or alternatively the WEDM system with the aid of 3R-SP6435.
Angle shelf, Wire EDM
3R-201.5
Mounts directly on the machine table. For vertical mounting of a Macro chuck or short reference element in the machine.
Wire alignment unit, Wire EDM
3R-220.3
Unit with double-insulated reference contacts for wire alignment.
Automatic indexing chuck, Wire EDM
D-30206
Pneumatic built-in chucks for Macro holders. Can also be used in milling and grinding operations without high cutting forces.
Air unit, Wire EDM
3R-611.60
Unit for operating pneumatic chucks in B-axes. Two functions – open/closed with four seconds delay for air-blast cleaning.