Tooling for EDM
397 results for 'Tooling for EDM'
Plate 5.5 mm, MacroJunior
3R-SP19270
Used in combination with 3R-491E when electrode blanks are mounted with adhesive and screws*. Permits mounting in MacroCombi chucks.
Plate 10 mm, MacroJunior
3R-SP19269
Used in combination with 3R-491E when soldering round (<50 mm) or square (<40 mm) copper blanks. Permits mounting in MacroCombi chucks.
Holder 25 mm, MacroJunior
3R-461-8.8-HP
Upper and lower faces ground parallel within 0.002 mm. Locating pin Ø8.8 mm (0/0.05 mm).
Holder with taper, MacroJunior
3R-465.1E-A
The taper is machined suitably for attaching very small electrodes. To be mounted on 3R-491E with three screws MFT4x12.
Electrode holder Ø20 mm, Mini
3R-322-50E
Holder with hardened reference part and unhardened electrode mounting part.
Manual chuck, MacroHP
3R-600.24-4RS
Rust resistant chuck for Macro holder. Mounts on a suitable fixture.
Pneumatic built-in chuck, Matrix185
3R-SP28268
Chuck for permanent mounting in the machine table or into a PM press.
Drawbar, Matrix185
3R-695.2-185
Note: In automation the gripper has to grip on the pallet and not on the drawbar.