Tooling for parts production
416 results for 'Tooling for parts production'
Pneumatic chuck, MacroHP
3R-SP7359
Pneumatic chuck for building-in, for example in a fixture, dividing head or B-axis.
Pneumatic chuck, MacroStd
3R-600.84-30
Pneumatic chuck for permanent mounting in the machine spindle. Note: XYZ-references of hardened and ground steel, larger Z-references. Note: When ordering state machine make and type.;
Pneumatic chuck, MacroStd
3R-600.86-30
Pneumatic chuck for permanent mounting in the machine spindle. Note: When ordering state machine make and type. Note: X/Y/Z references of hardened and ground steel, larger Z-references.
Pneumatic built-in chuck, Matrix142
3R-SP28219-RS
Rust resistant chuck for permanent mounting in the machine table.
Drawbar, Matrix142
3R-695.2-142RS
Note: In automation the gripper has to grip on the pallet and not on the drawbar.
Collet chuck ER20, Matrix142
3R-699.20-142D
The pallet can be flipped over to gain access from rear side.
Manual chuck, MacroStd
3R-610.21-S
Two ground faces for vertical or horizontal mounting on the machine table.
Manual chuck, MacroStd
90842
Two ground faces for vertical or horizontal mounting on the machine table.
Pneumatic chuck (low profile), MacroStd
3R-602.81
Pneumatic chuck for permanent mounting on the machine table.