Tooling for wire EDM
144 results for 'Tooling for wire EDM'
Presetting kit, Econo, Wire EDM
3R-228EI
Mounting stone with bushings and holes for mounting chuck/reference elements. Use together with existing measuring machine or surface plate. Note: 3R-228EI delivers with dial indiactor measuring inch.
Sine ruler, Wire EDM
3R-216
With magnetic attachments for setting angles on swivelling elements. Angles are set with gauge blocks.
Sine ruler, Macro, Wire EDM
3R-216.6
For setting angles on swivelling elements. Angles are set with gauge blocks.
Reference element WEDM, Wire EDM
3R-200.1J-U
Universal 150 mm reference element, with oval holes, for all machines that have M8 holes in the machine table, 30 to 40 mm from the edge of the table.
Reference element WEDM, Wire EDM
3R-200.XJ-X
Reference elements for machines with zero-line table. The length (L), hole spacing (C) and hole edge spacing (B) of the hardened reference elements are matched to the machine in question. Note: When ordering, state machine mark and type.
Manual chuck, Macro
3R-602.27-1
Chuck adapter with lever for Macro holder in the WEDM system. Note: When mounted on the reference element, the two clamping jaws must be tightened with the same torque, 4 Nm.
Manual chuck, MacroJunior
3R-422.2
Chuck adapter with axial locking screw for MacroJunior holders in the WEDM system.