Tooling for EDM
397 results for 'Tooling for EDM'
Manual chuck, MacroHP
3R-600.20
For mounting on the machine spindle with 3R-A3620 or on a lathe taper with centring ring 3R-612.6.
Pneumatic chuck, MacroStd
3R-600.1-30
Pneumatic chuck for permanent mounting on the machine spindle or onto the machine table or as a lathe chuck.
Manual chuck, MacroStd
3R-610.21
Three ground faces for vertical or horizontal mounting on the machine table.
Manual chuck, MacroStd
3R-610.21-S
Two ground faces for vertical or horizontal mounting on the machine table.
Collet chuck ER20, Matrix110
3R-699.20-110D
The pallet can be flipped over to gain access from rear side.
Manual chuck adapter, Matrix110-Ø20
3R-SP31380-RS
Intended to fit cut tools with Ø20 mm. Also adapted to fit System 3R Mini electrode holders with Ø20 mm.
Pneumatic built-in chuck, Matrix142
3R-SP28219-RS
Rust resistant chuck for permanent mounting in the machine table.
Drawbar, Matrix142
3R-695.2-142RS
Note: In automation the gripper has to grip on the pallet and not on the drawbar.
Collet chuck ER20, Matrix142
3R-699.20-142D
The pallet can be flipped over to gain access from rear side.