Tooling for wire EDM
144 results for 'Tooling for wire EDM'
Sine ruler, Wire EDM
3R-216
With magnetic attachments for setting angles on swivelling elements. Angles are set with gauge blocks.
Sine ruler, Macro, Wire EDM
3R-216.6
For setting angles on swivelling elements. Angles are set with gauge blocks.
Control rod, Wire EDM
3R-606.2
Master for determining the position of vertical Macro chucks. Cylinder ground to the Macro references. Supplied with engraved dimensions in the X-, Y- and Z-directions.
Pneumatic chuck, MacroTwin, Wire EDM
3R-602.12-1
Pneumatic chuck for Macro or MacroTwin. Horizontal mounting on the machine table. Note: On automatic changing with WorkPal - MacroTwin holders only.
Manual chuck, Macro, Wire EDM
3R-600.23RS
Manual chuck with mounting flange for Macro holder. Designed for permanent mounting.
Manual chuck (low profile), MacroMagnum, Wire EDM
3R-680.24RS
Chuck for MacroMagnum holder. For permanent mounting on the machine spindle or table. Note: Master 3R-606.1 or 3R-686.1-HD required at installation.
Pneumatic chuck (low profile), Macro, Wire EDM
90945.01
Pneumatic chuck for permanent mounting on the machine table.
Angle Tool, Macro, Wire EDM
D-30215
Angle tool, Macro with vernier scale -90º to 0 to +90º. Note: Macro chuck is required on the machine table for clamping.