Tooling for wire EDM
144 results for 'Tooling for wire EDM'
Presetting kit, Econo, Wire EDM
3R-228EI
Mounting stone with bushings and holes for mounting chuck/reference elements. Use together with existing measuring machine or surface plate. Note: 3R-228EI delivers with dial indiactor measuring inch.
Manual chuck, Macro, Wire EDM
3R-600.23RS
Manual chuck with mounting flange for Macro holder. Designed for permanent mounting.
Manual chuck (low profile), MacroMagnum, Wire EDM
3R-680.24RS
Chuck for MacroMagnum holder. For permanent mounting on the machine spindle or table. Note: Master 3R-606.1 or 3R-686.1-HD required at installation.
Pneumatic chuck (low profile), Macro, Wire EDM
90945.01
Pneumatic chuck for permanent mounting on the machine table.
Angle Tool, Macro, Wire EDM
D-30215
Angle tool, Macro with vernier scale -90º to 0 to +90º. Note: Macro chuck is required on the machine table for clamping.
3R-block, Macro, Wire EDM
3R-217-1
Manual Macro chuck. For vertical or horizontal mounting on the machine table, or alternatively the WEDM system with the aid of 3R-SP6435.
Angle shelf, Wire EDM
3R-201.5
Mounts directly on the machine table. For vertical mounting of a Macro chuck or short reference element in the machine.
Machine-adapted B-axis, Wire EDM
3R-60.360X
Compact Rotary Indexing Tables with pneumatic Macro chuck. Indexing 0-360° with smallest step 0.001°. Air connections for open/close, as well as turbo-locking/air-blast cleaning. Note: The units are controlled by the machine.The mark and type of the machine must therefore be stated when ordering.