Tooling for wire EDM
106 results for 'Tooling for wire EDM'
Automatic indexing chuck, Wire EDM
D-30206
Pneumatic built-in chucks for Macro holders. Can also be used in milling and grinding operations without high cutting forces.
Rotation table with Matrix 185 interface, Wire EDM
D-30229-3
Rotation table with Matrix 185 interface. Note: The units are controlled by the machine. The mark and type of the machine must therefore be stated when ordering.
Air unit, Wire EDM
3R-611.60
Unit for operating pneumatic chucks in B-axes. Two functions – open/closed with four seconds delay for air-blast cleaning.
Reference element WEDM, Wire EDM
3R-200.1J-U
Universal 150 mm reference element, with oval holes, for all machines that have M8 holes in the machine table, 30 to 40 mm from the edge of the table.
Reference element WEDM, Wire EDM
3R-200.XJ-X
Reference elements for machines with zero-line table. The length (L), hole spacing (C) and hole edge spacing (B) of the hardened reference elements are matched to the machine in question. Note: When ordering, state machine mark and type.
Manual chuck, Macro
3R-602.27-1
Chuck adapter with lever for Macro holder in the WEDM system. Note: When mounted on the reference element, the two clamping jaws must be tightened with the same torque, 4 Nm.
Manual chuck, MacroJunior
3R-422.2
Chuck adapter with axial locking screw for MacroJunior holders in the WEDM system.
Manual chuck adapter, MacroJunior
3R-466.40RS
Chuck adapter, stainless steel, for MacroJunior holders in the Macro system. Axial locking screw.
Manual chuck adapter, Mini
3R-252.1
Chuck adapter with dual hydraulic chambers for Mini holders in the WEDM-system.