Tooling for EDM
397 results for 'Tooling for EDM'
Manual chuck adapter 90°, Macro-Macro
3R-652.9
For horizontal mounting of Macro holders. Supplied with drawbar for screw locking.
Manual chuck adapter 90°, Macro-MacroJunior
3R-406.9
For horizontal mounting of MacroJunior holders in the Macro system. Screw locking.
Manual chuck adapter 90°, MacroJunior
3R-467.9-1
For horizontal mounting of MacroJunior holders. Screw locking. Note: For EDM machining only..
Pallet 25 mm, MacroJunior
3R-491E
For copper or graphite electrodes. NOTE: The electrode is installed with screw and adhesive assembly, or alternatively brazing.
Holder with journal, MacroJunior
3R-461.1E-GA
Holder with journal , 3R-461.1E-GA Journal Ø10x10 mm. Intended mainly for graphite electrodes. To be mounted on 3R-491E with three MFT4x12 screws and adhesive.
Plate 5.5 mm, MacroJunior
3R-SP19270
Used in combination with 3R-491E when electrode blanks are mounted with adhesive and screws*. Permits mounting in MacroCombi chucks.
Plate 10 mm, MacroJunior
3R-SP19269
Used in combination with 3R-491E when soldering round (<50 mm) or square (<40 mm) copper blanks. Permits mounting in MacroCombi chucks.
Holder 25 mm, MacroJunior
3R-461-8.8-HP
Upper and lower faces ground parallel within 0.002 mm. Locating pin Ø8.8 mm (0/0.05 mm).
Holder with taper, MacroJunior
3R-465.1E-A
The taper is machined suitably for attaching very small electrodes. To be mounted on 3R-491E with three screws MFT4x12.
Reference element Ø75 mm, MacroNano
3R-651.75E-N
Hardened and precision-cast with clearance holes for eight fixing screws. Note: Must be mounted on the workpiece/fixture before it is locked in a chuck.