Tooling for wire EDM
144 results for 'Tooling for wire EDM'
Manual chuck (low profile), MacroMagnum, Wire EDM
3R-680.24RS
Chuck for MacroMagnum holder. For permanent mounting on the machine spindle or table. Note: Master 3R-606.1 or 3R-686.1-HD required at installation.
Pneumatic chuck (low profile), Macro, Wire EDM
90945.01
Pneumatic chuck for permanent mounting on the machine table.
3R-block, Macro, Wire EDM
3R-217-1
Manual Macro chuck. For vertical or horizontal mounting on the machine table, or alternatively the WEDM system with the aid of 3R-SP6435.
Rotation table with Matrix 185 interface, Wire EDM
D-30229-3
Rotation table with Matrix 185 interface. Note: The units are controlled by the machine. The mark and type of the machine must therefore be stated when ordering.
Air unit, Wire EDM
3R-611.60
Unit for operating pneumatic chucks in B-axes. Two functions – open/closed with four seconds delay for air-blast cleaning.
Reference element WEDM, Wire EDM
3R-200.1J-U
Universal 150 mm reference element, with oval holes, for all machines that have M8 holes in the machine table, 30 to 40 mm from the edge of the table.