Tooling for EDM
397 results for 'Tooling for EDM'
Pneumatic built-in chuck, Matrix142
3R-SP28219
Chuck for permanent mounting in the machine table or into a PM press.
Drawbar, Matrix185
3R-695.2-185
Note: In automation the gripper has to grip on the pallet and not on the drawbar.
Drawbar, Matrix220
3R-695.2-220
Note: In automation the gripper has to grip on the pallet and not on the drawbar.
Drawbar, Matrix260
3R-695.2-260
Note: In automation the gripper has to grip on the pallet and not on the drawbar.
Pneumatic chuck, MacroCombi
3R-SP18286
Pneumatic chuck for building-in, for example in a fixture, dividing head or B-axis.
Pneumatic chuck, MacroCombi
3R-SP19047
Pneumatic chuck for building-in, for example in a fixture, dividing head or B-axis.
Manual chuck adapter 90°, MacroJunior
3R-467.9-1
For horizontal mounting of MacroJunior holders. Screw locking. Note: For EDM machining only..
Holder 25 mm, MacroJunior
3R-461-8.8-HP
Upper and lower faces ground parallel within 0.002 mm. Locating pin Ø8.8 mm (0/0.05 mm).
Holder with taper, MacroJunior
3R-465.1E-A
The taper is machined suitably for attaching very small electrodes. To be mounted on 3R-491E with three screws MFT4x12.
Pneumatic chuck adapter, Dynafix
3R-772-680A
Chuck adapter with built-in pneumatic MacroMagnum chuck for mounting in 3R-770-1A or similar. See Dynafix for further information.