Tooling for wire EDM
144 results for 'Tooling for wire EDM'
Presetting kit, Econo, Wire EDM
3R-228EI
Mounting stone with bushings and holes for mounting chuck/reference elements. Use together with existing measuring machine or surface plate. Note: 3R-228EI delivers with dial indiactor measuring inch.
Automatic indexing chuck, Wire EDM
D-30206
Pneumatic built-in chucks for Macro holders. Can also be used in milling and grinding operations without high cutting forces.
Rotation table with Matrix 185 interface, Wire EDM
D-30229-3
Rotation table with Matrix 185 interface. Note: The units are controlled by the machine. The mark and type of the machine must therefore be stated when ordering.
Air unit, Wire EDM
3R-611.60
Unit for operating pneumatic chucks in B-axes. Two functions – open/closed with four seconds delay for air-blast cleaning.
Reference element WEDM, Wire EDM
3R-200.1J-U
Universal 150 mm reference element, with oval holes, for all machines that have M8 holes in the machine table, 30 to 40 mm from the edge of the table.
Reference element WEDM, Wire EDM
3R-200.XJ-X
Reference elements for machines with zero-line table. The length (L), hole spacing (C) and hole edge spacing (B) of the hardened reference elements are matched to the machine in question. Note: When ordering, state machine mark and type.
Manual chuck adapter, Mini
3R-252.1
Chuck adapter with dual hydraulic chambers for Mini holders in the WEDM-system.
MiniBlock, Mini
3R-202
Manual chuck with dual hydraulic chambers for Mini holders. Vertical or horizontal mounting in the WEDM system.