Tooling for wire EDM
144 results for 'Tooling for wire EDM'
Unimatic Adapter SuperVice/Macro WEDM, Wire EDM
C950480
Adapter for System 3R clamping elements with adaptation height 15 / 25 mm: with Unimatic dovetail slide.
Pneumatic chuck (low profile), Macro, Wire EDM
90945.01
Pneumatic chuck for permanent mounting on the machine table.
Angle Tool, Macro, Wire EDM
D-30215
Angle tool, Macro with vernier scale -90º to 0 to +90º. Note: Macro chuck is required on the machine table for clamping.
3R-block, Macro, Wire EDM
3R-217-1
Manual Macro chuck. For vertical or horizontal mounting on the machine table, or alternatively the WEDM system with the aid of 3R-SP6435.
Reference stop, Wire EDM
3R-225.2
For positioning 3Ruler anywhere on the reference elements. The stops have adjusting screws for accurate alignment.
Double 3Ruler vice, Wire EDM
3R-239.11
Movable jaws for mounting two rectangular workpieces at the same time. Detachable Z-support tabs ensure simple setting-up.
Vice, Wire EDM
3R-294.2
For clamping workpieces up to 50 mm. Mounts on 3R-237.2, 3R-294, 3R-292.66HP or a ruler in the 3Ruler system or Macropallet 54x54 mm.
Vice, Wire EDM
3R-294.1
For clamping workpieces up to 17 mm. Mounts on 3R-237.2, 3R-294, 3R-292.66HP or rulers in the 3Ruler system.
Multiple holder, Wire EDM
3R-294.6
For mounting four workpieces Ø5-13 mm at the same time. Mounts on 3R-237.2, 3R-294, 3R-292.66HP or a ruler in the 3Ruler system.