Tooling for wire EDM
144 results for 'Tooling for wire EDM'
Unimatic Adapter SuperVice/Macro WEDM, Wire EDM
C950480
Adapter for System 3R clamping elements with adaptation height 15 / 25 mm: with Unimatic dovetail slide.
Adapter, Wire EDM
C950280
For mounting Unimatic holders in WEDM, Macro and MacroTwin mounting heads.
Pneumatic chuck, MacroTwin, Wire EDM
3R-602.12-1
Pneumatic chuck for Macro or MacroTwin. Horizontal mounting on the machine table. Note: On automatic changing with WorkPal - MacroTwin holders only.
Manual chuck, Macro, Wire EDM
3R-600.23RS
Manual chuck with mounting flange for Macro holder. Designed for permanent mounting.
Automatic indexing chuck, Wire EDM
D-30206
Pneumatic built-in chucks for Macro holders. Can also be used in milling and grinding operations without high cutting forces.
Rotation table with Matrix 185 interface, Wire EDM
D-30229-3
Rotation table with Matrix 185 interface. Note: The units are controlled by the machine. The mark and type of the machine must therefore be stated when ordering.
Air unit, Wire EDM
3R-611.60
Unit for operating pneumatic chucks in B-axes. Two functions – open/closed with four seconds delay for air-blast cleaning.