Tooling for powder compacting
45 Ergebnisse für 'Tooling for powder compacting'
Fixture for punch, Macro
90238
Fixture for punch on Macro, in order to wire-cut a through hole within Ø20 mm.
Clamping force meter Ø72 mm, Macro
3R-SSP122
Intended for checking clamping force of Matrix chucks and for those Macro chucks found in compacting machines (due to cramped and limited space inside machine). In order to check Matrix chucks, see additional converter kits 3R-SSP115MATRIX nnn enabling checking.
Lifting device, Matrix110 and Matrix142
3R-692.8-142
In combination with 3R-692.7-110 and 3R-692.7-142 to enable lift by crane.
Lifting device, Matrix185 and Matrix220
3R-692.8-220
In combination with 3R-692.7-185 and 3R-692.7-220 to enable lift by crane.
Punch alignment system
D-20158-BASE
This fixture enables adjustment of punches within metal powder compacting by Macro system. The fixture is a stand-alone unit. It is possible to replace the indicators with electrical sensors. Free access from underneath, to access fixation-screws for the pallets.
3Refix PM mandrel, Ø10 mm, 3Refix
3R-901-10PM-TX
Note: When positioning with 3Refix mandrels –always tighten the expanding mandrel in the R0 hole first.