Tooling for EDM
397 Ergebnisse für 'Tooling for EDM'
Pallet 25 mm, ground, MacroJunior
3R-491E-HP
Top and bottom faces parallel-ground to within 0.002 mm. NOTE: The electrode is installed with screw and adhesive assembly, or alternatively brazing.
Holder with journal, MacroJunior
3R-461.1E-GA
Holder with journal , 3R-461.1E-GA Journal Ø10x10 mm. Intended mainly for graphite electrodes. To be mounted on 3R-491E with three MFT4x12 screws and adhesive.
Holder with taper, MacroJunior
3R-465.1E-A
The taper is machined suitably for attaching very small electrodes. To be mounted on 3R-491E with three screws MFT4x12.
Reference element Ø75 mm, MacroNano
3R-651.75E-N
Hardened and precision-cast with clearance holes for eight fixing screws. Note: Must be mounted on the workpiece/fixture before it is locked in a chuck.
Collet chuck ER40, Matrix142
3R-699.40-142D
The pallet can be flipped over to gain access from rear side.
Control ruler, MacroNano
3R-606-N
Control ruler with ground C-reference for setting MacroNano chucks.
Control ruler, Matrix142
3R-696.1-142
For setting flatness and angular positions. Ground hole for centering.
Manual chuck, MacroStd
3R-600.23-S
Cast chuck with mounting flange for mounting on the machine spindle or in a fixture.
Pneumatic chuck, Matrix185
3R-690.1-185-RS
Rust resistant chuck for permanent mounting on the machine table.