Tooling for EDM
260 Ergebnisse für 'Tooling for EDM'
Electrode holder Ø20 mm, Mini
3R-322-50E
Holder with hardened reference part and unhardened electrode mounting part.
Pneumatic chuck, Matrix185
3R-690.1-185
Chuck for permanent mounting on the machine table or into a PM press.
Drawbar, Matrix185
3R-695.2-185
Note: In automation the gripper has to grip on the pallet and not on the drawbar.
Drawbar, Matrix220
3R-695.2-220
Note: In automation the gripper has to grip on the pallet and not on the drawbar.
Drawbar, Matrix260
3R-695.2-260
Note: In automation the gripper has to grip on the pallet and not on the drawbar.
Pneumatic chuck, MacroCombi
3R-460.83-2
Pneumatic chuck for mounting directly on the machine spindle. All XYZ-references in hardened and ground steel. Note: When ordering state machine make and type.;
Manual chuck, MacroJunior
3R-410.31-5
Chuck in High Performance version. Five ground surfaces for vertical or horizontal mounting on the machine table.
Manual chuck, MacroJunior
3R-SP19143
Stainless steel chuck with ground flange Ø22x6 mm for mounting in a fixture or the WEDM system. Axial locking screw with channel for flushing through the electrode.
Holder 25 mm, MacroJunior
3R-461-8.8-HP
Upper and lower faces ground parallel within 0.002 mm. Locating pin Ø8.8 mm (0/0.05 mm).
Holder with taper, MacroJunior
3R-465.1E-A
The taper is machined suitably for attaching very small electrodes. To be mounted on 3R-491E with three screws MFT4x12.