Tooling for wire EDM
144 Ergebnisse für 'Tooling for wire EDM'
Presetting kit, Econo, Wire EDM
3R-228EI
Mounting stone with bushings and holes for mounting chuck/reference elements. Use together with existing measuring machine or surface plate. Note: 3R-228EI delivers with dial indiactor measuring inch.
Sine ruler, Wire EDM
3R-216
With magnetic attachments for setting angles on swivelling elements. Angles are set with gauge blocks.
Vice, Macro, Wire EDM
3R-613.6
Vice for mounting rectangular workpieces 0-80 mm in the Macro system. Movable jaws for centred mounting. Can be supplemented with insert 16115-00 for mounting round workpieces 15-55 mm.
Control rod, Wire EDM
3R-606.2
Master for determining the position of vertical Macro chucks. Cylinder ground to the Macro references. Supplied with engraved dimensions in the X-, Y- and Z-directions.
Control ruler, Wire EDM
3R-206.10
Control ruler for horizontal Macro chucks. One long side ground to the Macro references. Supplied with engraved dimensions in the X-, Y- and Z-directions.
Levelling adapter, Wire EDM
3R-272HP
For manual mounting of SuperVice, a holder or a fixture in the WEDM system. Note: All holders including HP can be mounted. Also fits the ICS system if the clamping jaw (17850-00) is changed.
Levelling adapter, Macro
3R-262HP
For mounting SuperVice, a holder or a fixture in the Macro system. Note: All holders including HP can be mounted.
Fixed mounting head, Wire EDM
3R-266.4
For manual mounting of SuperVice, a holder or a fixture in the Macro system. Note: All holders including HP can be mounted.
Fixed mounting head, Macro
3R-266.5
For mounting SuperVice, a holder or a fixture in the Macro system. Note: All holders including HP can be mounted.
Levelling adapter, MacroTwin
3R-282.12HP
For mounting Magnum holders in the MacroTwin system. Note: All holders including HP can be mounted.
Fixed mounting head, MacroTwin
3R-266.12HP
For manual mounting of Magnum holders in the MacroTwin system. Note: All holders including HP can be mounted