Tooling for wire EDM
144 Ergebnisse für 'Tooling for wire EDM'
Unimatic Adapter SuperVice/Macro WEDM, Wire EDM
C950480
Adapter for System 3R clamping elements with adaptation height 15 / 25 mm: with Unimatic dovetail slide.
Manual chuck (low profile), MacroMagnum, Wire EDM
3R-680.24RS
Chuck for MacroMagnum holder. For permanent mounting on the machine spindle or table. Note: Master 3R-606.1 or 3R-686.1-HD required at installation.
Automatic indexing chuck, Wire EDM
D-30206
Pneumatic built-in chucks for Macro holders. Can also be used in milling and grinding operations without high cutting forces.
Rotation table with Matrix 185 interface, Wire EDM
D-30229-3
Rotation table with Matrix 185 interface. Note: The units are controlled by the machine. The mark and type of the machine must therefore be stated when ordering.
Air unit, Wire EDM
3R-611.60
Unit for operating pneumatic chucks in B-axes. Two functions – open/closed with four seconds delay for air-blast cleaning.
Manual chuck, MacroJunior
3R-422.2
Chuck adapter with axial locking screw for MacroJunior holders in the WEDM system.
Manual chuck adapter, MacroJunior
3R-466.40RS
Chuck adapter, stainless steel, for MacroJunior holders in the Macro system. Axial locking screw.