Tooling for EDM

3R-460.83-2

Pneumatic chuck for mounting directly on the machine spindle. All XYZ-references in hardened and ground steel. Note: When ordering state machine make and type.;

3R-460.31-5

Chuck in HighPerformance version. Five ground surfaces for vertical or horizontal mounting on the machine table.

3R-460.37

The locking mechanism is operated by a removable handle.

3R-460.46

Pneumatic chuck with integral air unit.

3R-SP18286

Pneumatic chuck for building-in, for example in a fixture, dividing head or B-axis.

3R-SP19047

Pneumatic chuck for building-in, for example in a fixture, dividing head or B-axis.

3R-SP19269

Used in combination with 3R-491E when soldering round (<50 mm) or square (<40 mm) copper blanks. Permits mounting in MacroCombi chucks.

3R-465.1E-A

The taper is machined suitably for attaching very small electrodes. To be mounted on 3R-491E with three screws MFT4x12.

3R-469-10

Chuck for collets ETS10.

3R-469-16

Chuck for collets ER16.

3R-465-LE

For round electrodes Ø4-8 mm or square < 8x18 mm, and with maximum height 30 mm.

3R-494-D10x50

Blanks mounted on MacroJunior holders for the manufacture of electrodes. The stock range is matched to local preferences and ways of working. This applies to electrode materials, different grades of graphite and copper, and to dimensions. Contact your local 3R representative for further information. The System 3R factory can supply holders with factory-mounted copper blanks in sets of ten.