Tooling for EDM
289 Ergebnisse für 'Tooling for EDM'
Electrode holder Ø20 mm, Mini
3R-322-50E
Holder with hardened reference part and unhardened electrode mounting part.
Pneumatic chuck, Matrix185
3R-690.1-185
Chuck for permanent mounting on the machine table or into a PM press.
Pneumatic chuck, Matrix142
3R-690.1-142
Chuck for permanent mounting on the machine table or into a PM press.
Pneumatic built-in chuck, Matrix220
3R-SP28340
Chuck for permanent mounting in the machine table or into a PM press.
Pneumatic built-in chuck, Matrix110
3R-SP28395
Chuck for permanent mounting in the machine table or into a PM press.
Pneumatic built-in chuck, Matrix185
3R-SP28268
Chuck for permanent mounting in the machine table or into a PM press.
Pneumatic chuck, Matrix110
3R-690.1-110
Chuck for permanent mounting on the machine table or into a PM press.
Pneumatic built-in chuck, Matrix142
3R-SP28219
Chuck for permanent mounting in the machine table or into a PM press.
Holder 25 mm, MacroJunior
3R-461-8.8-HP
Upper and lower faces ground parallel within 0.002 mm. Locating pin Ø8.8 mm (0/0.05 mm).
Holder with taper, MacroJunior
3R-465.1E-A
The taper is machined suitably for attaching very small electrodes. To be mounted on 3R-491E with three screws MFT4x12.
Reference tables, 3Refix
3R-936-60.38
Reference tables of structurally-stable toughened steel (270-320 HB). Hardened bushes in dead-end holes for 3Refix mandrels Ø20 mm at 100x100 mm modular spacing, as well as M12 tapped mounting holes with 50x50 mm modular spacing. Note: Customised reference tables can be made to order. Note: Hardened reference tables (650-700 HB) can be made to order.