Tooling for EDM
397 Ergebnisse für 'Tooling for EDM'
Manual chuck, MacroHP
3R-600.24-4RS
Rust resistant chuck for Macro holder. Mounts on a suitable fixture.
Manual chuck adapter 90°, Macro-MacroJunior
3R-406.9
For horizontal mounting of MacroJunior holders in the Macro system. Screw locking.
Electrode holder Ø20 mm, Mini
3R-322-50E
Holder with hardened reference part and unhardened electrode mounting part.
Pneumatic chuck, Matrix185
3R-690.1-185
Chuck for permanent mounting on the machine table or into a PM press.
Pneumatic chuck, Matrix142
3R-690.1-142
Chuck for permanent mounting on the machine table or into a PM press.
Pneumatic built-in chuck, Matrix220
3R-SP28340
Chuck for permanent mounting in the machine table or into a PM press.
Pneumatic built-in chuck, Matrix142
3R-SP28219
Chuck for permanent mounting in the machine table or into a PM press.
Plate 10 mm, MacroJunior
3R-SP19269
Used in combination with 3R-491E when soldering round (<50 mm) or square (<40 mm) copper blanks. Permits mounting in MacroCombi chucks.
Holder 25 mm, MacroJunior
3R-461-8.8-HP
Upper and lower faces ground parallel within 0.002 mm. Locating pin Ø8.8 mm (0/0.05 mm).
Holder with taper, MacroJunior
3R-465.1E-A
The taper is machined suitably for attaching very small electrodes. To be mounted on 3R-491E with three screws MFT4x12.