Tooling for powder compacting
45 Ergebnisse für 'Tooling for powder compacting'
Lifting device, Matrix185 and Matrix220
3R-692.8-220
In combination with 3R-692.7-185 and 3R-692.7-220 to enable lift by crane.
Punch alignment system
D-20158-BASE
This fixture enables adjustment of punches within metal powder compacting by Macro system. The fixture is a stand-alone unit. It is possible to replace the indicators with electrical sensors. Free access from underneath, to access fixation-screws for the pallets.
Alignment tool & control Z-distance, Macro PM
90909
Alignment and control tool for the Macro + 3Refix system in PM. Alignment is rough but helps reduce assembly time before final verification and alignment with verification tools. Also to be used to check parallelism between punch levels versus die-plate-level.
Die unit for Z-distance
D-20198-DZxx
Requires computer etc by D-20189-BASE. To be used in combination with punch unit D-20198-Zxx.
Punch unit for Z-distance, Macro
D-20198-Zxx
Tool to establish Z-distance in combination with either 3Refix or Matrix 142 pallet. This unit requires additional tool. It is possible to apply electrical or mechanical indicators while measuring top surface. Note: Linear probe is not included.
3Refix PM mandrel, Ø20 mm, 3Refix
3R-901-20PM-TX
Note: When positioning with 3Refix mandrels –always tighten the expanding mandrel in the R0 hole first.
3Refix PM mandrel, Ø10 mm, 3Refix
3R-901-10PM-TX
Note: When positioning with 3Refix mandrels –always tighten the expanding mandrel in the R0 hole first.
Manual chuck, MacroMagnum PM
3R-680.27-150
Manual chuck for permanent mounting in spindle of powder press machine.
Pneumatic chuck, Macro PM
90803.60
Pneumatic chuck for permanent mounting in spindle of powder press.